Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

Modeling

End Diaphragm for Semi-Integral Abutments

My agency uses a lot of semi-integral abutments. in this type of abutment, the girders extend over the abutment wall and are locked together with a large end diaphragm block that also provides the pavement seat for the approach slab. I have provid...
30 days ago in Modeling / OpenBridge Designer / OpenBridge Modeler Future consideration

Girder Stops for Abutments and Expansion Piers

My agency uses girder stops at abutments and expansion piers. These act as guides that allow the girders to move freely during expansion, contraction, and seismic events without falling off the bearings. Modeling these would allow for more accurat...
29 days ago in Modeling / OpenBridge Designer / OpenBridge Modeler Future consideration
264 VOTE

Ability to define the slope of any points within the dynamic section using the measure tools

Having the ability to quickly check both existing and design crossfall/superelevation would increase efficiency within the program as there would be no requirement to run a template and report to evaluate existing cross slopes
almost 4 years ago in Annotation / Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer Future consideration
258 VOTE

Ability to export and import all corridor objects such as point controls to enable rebuilding of corridors

I know parametric constraints can be exported but if a corridor becomes corrupt then being able to rebuild it from scratch easily would be useful. Similar to an input file in MX
almost 4 years ago in Import/Export / Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer Future consideration

Choosing Fatigue category for bolted stiffeners similar to Cross Frames

Product/Version: LBS v24.0.2.19 under OBD v24.0.2.15 Area: Steel Design / Fatigue Check / Stiffeners Current Behavior: In LBS, the fatigue check for stiffeners does not provide the user with an appropriate option to account for bolted stiffener de...
7 days ago in Modeling / OpenBridge Designer Future consideration
246 VOTE

Button to synchronize all template drops for all corridors & linear templates in a file

I'd like a tool that synchronizes all template drops in all corridors in a file, right now they have to each be manually selected in the explorer or on screen.
about 4 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface Future consideration

Horizontal feature constraint with option secondary alignment

have the option to set secondary alignment in the templates point properties.
9 days ago in Modeling / OpenRoads Designer Future consideration

Horizontal Range Option for Loop Alignment Modeling Controls

When modeling a loop ramp (or any situation where the alignment doubles back on itself) point controls and target aliases have a tendency to find solutions that are technically correct across the infield but that are not the intended solution. For...
6 months ago in Modeling / OpenRail Designer / OpenRoads Designer Future consideration
107 VOTE

Cut and Fill Lines Connect

In the previous Bentley software our DOT used, the software was able to connect the cut and fill lines when transitioning from cut and fill between template drops. Currently the only way that is possible is to have a feature name override on the c...
over 3 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer Future consideration
121 VOTE

Add "Point" column to the table in the Corridor Objects-Point Control window to show which point is being controlled

As a Highway Designer I want the Corridor Objects-Point Control window to include a column in the table that shows which point is being controlled so that I can sort based on that point name to quickly determine which point controls applied to tha...
about 4 years ago in Modeling / OpenRail Designer / OpenRoads Designer Planned