Beam haunches should have more robust parameters or even model templates. some examples would be: the ability to allow exterior haunches to extend to the edge of deck independent of the top flange of the girder/beam. also allow it to taper to a ...

Many times an alignment is partly existing and partly new or changed. In the drawings this should be shown with different symbology and annotation, something that is not easy in ORD. A tool that can do this would be very useful!

surface templates apply depth vertically, in many cases it is desired a true depth that is perpendicular to the terrain.

I'm not sure how best to implement it, but it's not uncommon to have multiple people working on a project with multiple corridor files. Having just one itl for the project would cause a lot of conflict and possible erros so multiple itl files are ...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

It would be very helpful to be able to put in different spacing for the shear stirrups than for the shear connectors between the beam and deck. I know older standard detailing had these all as one bar so the spacing would always be the same. Howev...

in InRoads ss2 the interface would display the point control and parametric constraints with red or blue of there stationing used to control a point overlapped another entry or extended beyond the limit of the alignment. This was a helpful visual ...

Currently, OpenRoads Designer does not support a native method for designing an end condition that targets both the terrain model and a specific elevation simultaneously without relying on external geometry such as contour lines or point controls....

Add the ability to target survey Feature Definitions with Horizontal Feature Constraints on Points within Templates. There is a deliverable required on surveyors to show cross sections of their surveyed surface where sections within the surface ha...

When setting a point control reference in InRoads, it would automatically set the limits to the start and end of that feature. I would like to see this as an option instead of only being able to lock to the start or end of the corridor/alignment. ...