Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

Applications

166 VOTE

Drawing layout from right to left - plan and profile.

Fundamental convention for technical drawing demands that the north arrow point to the top of the page. Often an alignment either provided by a client or already exiting will progress from right to left. This being said, when creating plan and pro...
about 4 years ago in Drawing Production / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer Shipped
134 VOTE

Functionality to import .12daz file format.

Be able to import strings from .12daz or any format native to 12D
almost 4 years ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer Shipped
116 VOTE

Access OBM directly instead of opening OBD first

It would really be helpful for users with OBD to not have to open OBD prior to opening OBM. That is a big pain point that I get a lot of complaints about. Also it is very confusing for users at first, they don't understand why they can't just clic...
about 2 years ago in OpenBridge Designer Shipped

import parcels, survey chains, lines, curves, spirals from GPK

Since GEOPAK is no longer supported. I have heard from Bentley time and time again that we can get to our data out of the GPK and import it into ORD. BUT this is only true for chains, profiles and points. What about Parcels? survey chains? lines? ...
over 3 years ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer Shipped

Ability to Place Geometry Points that use Parametric Cells

I would like Geometry Points to support using parametric cells.

Need COGO feature parity with InRoads and Geopak

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...
almost 4 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey / User Interface Shipped

Need bent plate connection plates for diaphragm and cross frames.

OBM does not currently allow for bent connection plates for diaphragms / cross frames. We need that ability to cover bridges skewed between 20 and 45 degrees.
over 1 year ago in OpenBridge Modeler Shipped

Allow the road slope to exceed the gutter cross slope

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

GEOPAK Drainage gave you inlet calcs after you placed an inlet and assigned a catchment without having to run a scenario. We need this functionality in ORD

In Geopak Drainage, once you place a node and attached a catchment, you were able to see inlet calculations. This let the user know if they needed to shift the box to have an allowable spread. It would be great if we could get that feedback withou...
12 months ago in Drainage and Utilities / OpenRoads Designer Shipped

Make the Point Analyze Tool usable in Read-Only files

You can't use the Analyze Point tool on read-only files presumably because it is trying to add annotation but sometimes people just want to check measurements such as slope between geometry in a read-only files and this is a very useful tool to do...
over 3 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer Shipped