Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...

Currently one could add an LLS part on a turnout. Unfortunately this is a standard value. Sometimes, when creating a horizontal geometry, it is necessary to ''shorten'' the LLS part (aka to place a fewer amount of long sleepers that a standard LLS...

Use the Geometry Connector with start and end elements chosen as turnouts. The converged result gives a disconnection between the regression alignment and the turnout. You can only discover it by zooming in to the closest possible view. A "Verify ...

Especially in reports but also in models we need to add information about turnout type including a letter showing towards which side looking from point 1 towards point 2, the branch is oriented. As it is now turnouts with Leading orientation will ...

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...

In railway engineering, there is a growing demand for positioning of the tongue in turnouts. The proposal is to introduce a new point in the Feature Definition of turnouts, making it possible to specify the distance from point .1 to the Tongue. Su...

For turnout annotation, we need to add turnout with LLS Extension from the library. I know that it is possible to add LLS radius value for a defined curved turnout in the library, but for a complex project where there are a lot of curved turnouts ...

We need the ability to get the profile elevation from the turnout points to the turnout report.

Users need the ability to specify different element templates for profile symbology of turnouts. Some rail clients in North America are using custom line styles for their turnouts. These custom line styles need to be different in the profile view,...