If I could select all shapes and have it create all catchments at once that would save a lot of time. It would be great to have a dialogue box pop up where defaults can be changed.

The window that pops up after a hydraulic model run for design or analysis includes a "Calculation Detailed Summary". The Link Summary tab does not currently show the designed link size. Showing the link size in the Link Summary tab will allow the...

For Conduits, on our 2D plans, we show a different linestyle for each size of pipe. In InRoads, we would enable centerline display using these different linestyles. This linestyle is a wide dashed line with solid edge lines. We cannot replicate th...

When a InRoads SDB file is imported for a Drainage model, there is no option to assign a ORD-"Wastewater node" to one of the nodes imported from SDB file. Only Drainage Nodes are available to define a feature definition. We need to have control ov...

There is currently no way to utilize multiple custom line styles (or element templates) for pipes in plan view for Drainage and Utilities so that they are tied to the drainage property and will update to the correct line style if the pipe size cha...

I would like to have the ability to put connection regions and connection points on opposite ends of cells, specifically aprons. Currently, the apron won't trim with this setup.

Named boundary and respective cut-sheet is based on the profile Run Alignment. In further submittal there might be a change (about 25-30%) in the Profile Run of respective system. If we delete the run the named boundary and cut-sheet will lose the...

Currently ORD does not have an option to calculate Time of Concentration for the channel flow that the state of Oklahoma uses. This eliminates the option to use the programmed Tc calculator for channel flow. I need an option to put in my own formu...

Add support for attaching station /offset for Links and Nodes "Set Out" points on. Currently Nodes only report the origin of the cell - which there is a bug in 10.11 version, but we need to also get the center point for eccentric structures. Start...

In the Extract from Graphic tool, the conduit feature definition needs to be set prior to the node feature definition to pull the appropriate corresponding nodes from the workspace. Could the conduit feature definition settings be listed above the...