Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Modeling

Showing 208 of 1394

Ability to pick individual point name to put a Point Control on when using Feature Name Override

When applying a point control, users should have the ability to choose the individual point name when there is also a Feature Name Override on the point. As of now only the override name shows up in the point control pick list, and it currently do...
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer 2 Future consideration

Apply Multiple Deck Point Controls by Station Ranges

There are many circumstances where the same Deck Template point needs to be Point Controlled onto multiple linear features. Currently the user needs to either create multiple decks/support lines or create Geometry that traces the original and join...
about 2 years ago in Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

ITL List Items

ability to see list of items with no feature definitions selected.
9 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

See all templates used within Template Dialogue

When using Create Template dialogue, it would be a good feature to have a section or list that could be pulled showing all of the templates used in the project folder.
9 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Need a way to analyze plan, profile, and xs simultaneously with sta/off information

there is no good tool that we have found that allows you to analyze plan, profile, xs simultaneously with sta/off & elev information.
9 months ago in Modeling / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Already exists

Ability in Surface Creation to Move Backward

Ability in surface creation to move backward. For instance, proposed top mesh for retaining walls will never be correct, because the coping and barrier wall being outside of the wall requires the surface to move in the opposite direction. This can...
9 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Create Cut Fill Volumes from one element

Extension of the "Create Cut Fill Volumes" function with the ability to choose whether calculations will be performed for a selected element (similar to the function "Create Closed Mesh") or for all elements included in the model (just like it's b...
5 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add Non-Modelled Volumes in Mass Diagram

In ORD 2023 there is no provision for manually adding non-modelled cut or fill volumes to a mass diagram or earthwork report. Manual volumes are typically used for borrowing sites, waste sites, non-modelled bridge embankments and merging models su...
9 months ago in Modeling / OpenRail Designer / OpenRoads Designer / Reports 0 Future consideration

Surcharge Volume Option

Add a Surcharge Volume Option for Meshes & Terrains. This would need to function so as to compare the Surcharge to Design and Existing volumes/terrains. Surcharge embankment will always be above finished or existing grade, so consider this as ...
9 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Set a view target point with the 3D Drive Through Tool

Ability to set a target point that the tool fixes on when driving down the alignment.
10 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration