Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

CANT

Showing 17 of 1152

Ability to separate the annotation of curves and spirals for the rail cant

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;
over 1 year ago in Annotation / CANT / OpenRail Designer 0 Future consideration

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
10 months ago in CANT / OpenRail Designer 0 Future consideration

Support "Apply Mainline Cant Through Turnout" in Create Cant command

This tool works for the branch geometry that is starting with a tunout. While creating the cant it applies the same cant value it read from main track geometry to the start of the turnout geometry. Also tool needs to have an option to change rotat...
over 1 year ago in CANT 0 Future consideration

Linking multiple cant alignments with a dependency into a referenced container model

My company plans to undertake large route alignments, but broken down into smaller alignment sections for different contract areas. Currently, we are 'stitching' the smaller sections into a routewide federated model by using Single Offset Entire E...
about 1 year ago in CANT / OpenRail Designer 2 Future consideration

Folders for Cant Tables

In order to use Cant Tables, a significant number of Cant Tables need to be created. As such, the ability to organize the tables into folders within the DGNLIB is needed.
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

Numerical display for applied cant

Recommended that a when using the cross-section tool to view the applied cant along the alignment, the tool displays the cant as numerical value on the cross-section. The number should be generated automatically and displayed next the chainage...
10 months ago in CANT / OpenRail Designer 0 Future consideration

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
5 months ago in CANT / Geometry / OpenRail Designer 0 Future consideration