Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Applications

Showing 1241 of 1386

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
10 months ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review

Allow cut and fill meshes to be created by named boundary

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...
almost 2 years ago in OpenRoads Designer 0 Future consideration

curved corners in bridge geometry

OBM should allow o define sharp corners for decks and barriers (in addition to rounded). Currently every turn is interpolated using spline type of line, without control from user end (regardless of the manipulation for the chord and distance betwe...
almost 2 years ago in Geometry / Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

Add FGE to Beam Elevation Report

It would be useful to have FGEs in the beam elevation report that correspond to the girder 10th points provided in that report
3 months ago in OpenBridge Modeler 0 Future consideration

Reverse direction of an existing complex element

A tool to reverse the direction of an existing complex element. There is a workaround by complexing the complex element but not an ideal solution.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Place Template from template library in a drawing

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Needs review

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Civil Cell dgnlib - Sort by name rather than date created

Currently Civil Cells are sorted by date created rather than by name when loaded from a dgnlib. This makes it very difficult to sort these. Oddly, when they are within a file (where the civil cell is "living") they sort by name.
10 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Coupling between horizontal and vertical regrerssion lines

A very problematic area is the coupling between horizontal and vertical regression analysis. Generally speaking, one must create a horizontal regression line first, create regressed elements, couple them together in a complex geometry and then pro...
over 1 year ago in OpenRail Designer / Regression Analysis 0 Future consideration