Activating a referenced dgn with geometry does not allow editing the Event Point List.

There is currently no way to view what cant ratios and related cant values the software is applying to the alignment. Nor is there an option to change the maximum and minimum values applied. The software should have an option to amend the followin...

Recommended that a when using the cross-section tool to view the applied cant along the alignment, the tool displays the cant as numerical value on the cross-section. The number should be generated automatically and displayed next the chainage...

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...

Needs a more efficient way to annotate existing top of rail elevations in a profile view.

Let's say there are 4 spans and the user defines a bridge with 5 supports and the deck and beam groups run from support 1 to support 5. Then the engineer learns that we don't want this long of a bridge, only 3 spans. Please add the ability to chan...

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...

We need better access and configuration for this constant. There is no place to set this constant.

Provide an option or new method to use the centerline radius (instead of inside lane radius) for divided highways that use a Crown pivot method. The Divided Inside pivot method already does this for divided highways that pivot about the inside lan...

Users should be allowed rename the Bearing group names and the individual bearings in a group.