Trench templates are used on pipes for fill quantities. It would be useful if you could place a trench that would automatically assign parametric constraints based on the size and pipe thickness of the pipes. Also, shapes other than a circle are d...

Issue: Can we have a feature similar to Plan/Profile Generator in BRT, where users can specify to create a plan/profile drawing in rows/columns (multiple drawings) in a single sheet instead of multiple sheet models like what is being done now in O...

Add a variant to the deck breakback that allows you to adjust the angle from the break point or add a deck variant that lets you set a distance from face of backwall which would automatically set your breakbacks without the need to give a distance...

Ability to annotate the slope between two linear features in plan. Currently we can only annotate station and offset but it is very common for designers to check cross slopes.

Reinforcement is typically tied together and is 3D modeled to reflect that. For example, a U bar tied into longitudinal/vertical bars. When a section cut is taken, the drawing models appears to show a single long U bar and not 2/3 separate bars. B...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

Ability to annotate superelevation transition locations (NC, LT, LR, FS, etc.) points with slope direction indicators in plan view.

In legacy versions of the software, I can have the template library open on one screen, corridor modeler on another screen, and the CAD window open on a third screen. I can make/save changes in the template, make/save changes in the corridor model...

When creating named boundaries of any time, a saved view is created for each named boundary. The creation of a saved view is a method that is supposed to control the look and feel of the drawing/sheet, but it is over-complicated, poorly understood...

Sometimes (especially when upgrading a file from a previous release to a later release) the ability to update drainage fields is lost or restricted to one area. It will be "greyed out" and unavailable for editing in the utilities properties window...