Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Applications

Showing 1219

Ablity to connect two nodes directly by flange

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Place Template from template library in a drawing

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Needs review

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

The Regression Tool need to be able to use or at least tie to Survey points.

The Regression Tool need to be able to use or at least tie to Survey points. I should be able to use Survey points in a DGN and in a reference. I need to have the survey points that are used in the regression appear in the regression report so tha...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Regression Analysis 0 Future consideration

Replace or swap master survey terrain without losing links or relationships

Replace or swap master survey terrain without losing links or relationships to design elements or other corridors, DGNs etc. I use a complex terrain to achieve this now, it would be nice to have another option
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

Add the overall Spiral PI station and Northing and Easting to all the Horizonal Alignment reports in CivilGeometry..

When comping existing alignments, we have a need to match the overall Spiral PI data. Adding this to the Report would make the workflow easier.
10 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Turnout in exportable file

It would be very useful to have a way of bringing geometry including turnouts between models i.e. as in the .alg files. Rather than having to use a dgn. With large alignment files, they are a lot more manageable/faster when split into smaller sect...
about 2 years ago in Geometry / Import/Export / OpenRail Designer 1 Future consideration

Reverse direction of an existing complex element

A tool to reverse the direction of an existing complex element. There is a workaround by complexing the complex element but not an ideal solution.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Allow cut and fill meshes to be created by named boundary

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...
almost 2 years ago in OpenRoads Designer 0 Future consideration