Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Applications

Showing 1244

Add Dimension Tool

There needs to be a Dimension Tool for adding/seeing dimensions that are not already present on the outside dimensions. Example - Standard Highway Sign Guide (2012) - D2-2 - Spacing for L currently cannot be shown in the program.
about 1 year ago in OpenRoads SignCAD 0 Future consideration

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
about 1 year ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Replace or swap master survey terrain without losing links or relationships

Replace or swap master survey terrain without losing links or relationships to design elements or other corridors, DGNs etc. I use a complex terrain to achieve this now, it would be nice to have another option
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

Allow cut and fill meshes to be created by named boundary

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...
almost 2 years ago in OpenRoads Designer 0 Future consideration

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
10 months ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review

curved corners in bridge geometry

OBM should allow o define sharp corners for decks and barriers (in addition to rounded). Currently every turn is interpolated using spline type of line, without control from user end (regardless of the manipulation for the chord and distance betwe...
almost 2 years ago in Geometry / Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

Reverse direction of an existing complex element

A tool to reverse the direction of an existing complex element. There is a workaround by complexing the complex element but not an ideal solution.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Place Template from template library in a drawing

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Needs review

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration