Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

OpenRoads Designer

Showing 974 of 1386

Add ability to Target Alias and clip a Conical Slope

The conical slope feature is very useful for model detailing. We use these often at bridge abutments. It would be helpful if we could target alias these features and also clip them.
about 2 years ago in Modeling / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer 0 Future consideration

Ability to use end condition exceptions on linear templates

Being able to use end condition exceptions for linear templates would be extremely beneficial for roadway designers. We often use end condition exceptions to turn off slopes in order to connect external features like ditches to the corridor. Not b...
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Add Offset Format options to the Baseline Offset Text Favorite

Add the Offset Format options that are available for the Point Offset text favorite (Positive Prefix, Negative Prefix, Positive Suffix, Negative Suffix, and Show Sign) to the Drainage Baseline Offset text favorite.
about 1 year ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Ablity to connect two nodes directly by flange

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Replace or swap master survey terrain without losing links or relationships

Replace or swap master survey terrain without losing links or relationships to design elements or other corridors, DGNs etc. I use a complex terrain to achieve this now, it would be nice to have another option
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Allow cut and fill meshes to be created by named boundary

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...
almost 2 years ago in OpenRoads Designer 0 Future consideration

Reverse direction of an existing complex element

A tool to reverse the direction of an existing complex element. There is a workaround by complexing the complex element but not an ideal solution.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Place Template from template library in a drawing

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Needs review

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Civil Cell dgnlib - Sort by name rather than date created

Currently Civil Cells are sorted by date created rather than by name when loaded from a dgnlib. This makes it very difficult to sort these. Oddly, when they are within a file (where the civil cell is "living") they sort by name.
10 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration