When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...

When I open a profile view, the default vertical exaggeration is 10. That is way too much. And I hate having to change it every time I open a profile view. Everyone is diffferent, though. I'm sure some folks love it. It would be nice if there was ...

As projects are still transitioning to ORD, I propose for a warning in ORD if someone tries to attach a reference dgn file that includes ss4/ss10 civil schema. As I understand it can be dangerous to mix these types of data especially if something ...

in Inroads there was an option to select points to put in regression in geometry to create a best fit alignment. You could then do a single element regression analysis afterwards and it would give you the best fit line and how far in either direct...

Currently, when exporting the Leap Bridge Steel (LBS) to perform substructure analysis, you can only export one live load vehicle at a time. Our project has two separate vehicles to be analyzed. One workaround is to export the loads, close the fil...

We need better access and configuration for this constant. There is no place to set this constant.

It will be helpful to see where the clipping is coming from. Example if reference file then would be helpful to know what reference file

When using text favorites that are based on an alignment (station/offset), these text favorites can break if the alignment changes or is dropped or it can't find it. As far as I know, when this happens, there is no way to reassign the text favorit...

When projecting various 2d geometry or 3d linear geometry the user is first required to set the active feature definition in the feature definition toolbar so that the project geometry shows up on the correct level, ect. It would speed things up i...

It appears that the software currently doesn’t allow sanitary conduit FDs to follow a slope even when the FD is set to depth of cover. it would be nice to tell the program to follow a given depth under the terrain, so I can see the pipe slope vary...