Multiple options should be available (node handles that can be manipulated, a match slope to conduit option in properties, a degree value that can be keyed-in, etc). This should allow for simplified placement of cell nodes that serve as pipe fitti...

Using OpenRail 2024 Vertical Frame Text significantly increases the height of Cross Sections, THUS causing more sheets. Would like the capability to have Horizontal Text in a frame, one row for Offset, one for Elevation. While this can be done, wh...

There can be a lot of instances on a project where a detail in a section is not practical to model 3D, and the user feels compelled draw the element live in the drawing model. It would be great to capture live elements with annotation groups, as t...

Beam haunches should have more robust parameters or even model templates. some examples would be: the ability to allow exterior haunches to extend to the edge of deck independent of the top flange of the girder/beam. also allow it to taper to a ...

Many times an alignment is partly existing and partly new or changed. In the drawings this should be shown with different symbology and annotation, something that is not easy in ORD. A tool that can do this would be very useful!

For now, the annotation of High and Low Points is very limited:# only one Low Point is detected - multiple low points are ignored# its is a linear3D annotation, and snaps on the annotations are not ruled (this intent is to be able to place drainag...

Corridor design input report provides much of what we need to reconstruct the corridor, but not a list of linework listed in the corridor attachments.

💡 Problem in Bentley Templates In Bentley software, defining dependencies between points requires creating a very large number of individual points. This makes templates complex, cluttered, and difficult to edit, since every relationship must be r...

surface templates apply depth vertically, in many cases it is desired a true depth that is perpendicular to the terrain.

When laying out watermain pipes the bends can be 45 degrees, 22.5 degrees, etc. These bends are modeled as nodes in our workspace so we can report of them and display them in our drawings. If the angle of the pipe adjusts, we want the node feature...