Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

All ideas

Showing 101

Annotate reverse point of reverse transition

Ability to annotate the reverse point of a reverse transition.
almost 2 years ago in Annotation / OpenRail Designer 3 Already exists

Allow user to change default settings

When I open a profile view, the default vertical exaggeration is 10. That is way too much. And I hate having to change it every time I open a profile view. Everyone is diffferent, though. I'm sure some folks love it. It would be nice if there was ...
almost 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 1 Already exists

horizontal regression for points

in Inroads there was an option to select points to put in regression in geometry to create a best fit alignment. You could then do a single element regression analysis afterwards and it would give you the best fit line and how far in either direct...
almost 2 years ago in Geometry 2 Already exists

Buttons in Level Display that stores and restores the status of levels

Once stored, it will keep track of which levels are turned on and off at the time of pressing stored. Then pressing restore will return the levels back to what they were. This would be useful if you needed to turn off some levels but want to retur...
about 2 years ago in User Interface 1 Already exists

label contours

label contours from inroads. there are times we have to label elevated "graphic" lines (aka contours and or benches without having a terrain model). was very helpful in inroads)
about 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 8 Already exists

Switching between referenced OBD models from an ORD file (after attachment).

If multiple bridge options are required, placing these options within the same dgn, but in separate models is a good practice. However, from ORD trying to change which OBD model is viewed (after it's been attached) does not work. It can be reattac...
about 2 years ago in User Interface 0 Already exists

Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
over 2 years ago in Geometry / OpenRoads Designer 0 Already exists

Ability to Change Feature Name of Element Within Complex Element

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.
over 2 years ago in Geometry / OpenRail Designer 0 Already exists

Ability to update profile drawing model element annotation without removing full model annotation.

Currently, the software does not respond to removing element annotation in the profile drawing models. Instead, the entire model needs to have annotations removed, re-annotated, and then the individual elements need to be annotated.
over 2 years ago in Annotation 1 Already exists

Modify default Height/Depth of a Node

In current version we do not have flexibility to change height/depth of a node from default 5.25 feet. At times we need lesser deep Nodes which does not require more than 1 or 2 feet of cover from soffit of conduit.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 4 Already exists