Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

Bentley Civil Product Ideas

Showing 1109

Ability to produce station base report for existing rail strings

A station base report between existing rail strings (left rail, right rail) to determine values in the xml report viewer for existing gauge and cant or sixfoot and stagger
about 2 years ago in OpenRail Designer / Reports 0 Future consideration

Vertical profile offset and snaps

ORD to allow vertical profile offset tool to snap to CAD lines. When alignments change horizontally, profile offsets do not retain snaps to features including CAD lines.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Create 3D by slope to target tool alse creates 2D geometry

This tool should work similar to a linear template. It should respect the "Create Template Geometry" option from the feature definition and generate the 2D geometry, not just the 3D one.
6 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ignore Specific Survey Observations

InRoads had the ability to ignore specific survey observations. If ORD had that same capability that would be fantastic.
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
about 1 year ago in CANT / Geometry / OpenRail Designer 0 Future consideration

Sync TM Filter with DGNLIB

There should be a way to sync a TM filter that is used in a DGN with the filter in the managed workspace DGNLIB
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 0 Future consideration

MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_DRAWING

Please add a variable MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_DRAWING that does what MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_SHEET does for sheets but for drawings

Annotate Points in Profile with sequential number

Want the ability to annotate every special point of the horizontal & vertical alignment with a number in sequence. You can veiw a sample of the profile annotation needed in the image below or in the PDF attached. This type of annotation is com...
about 2 years ago in Annotation 0 Future consideration

Add support for buildingSMART IDS

IDS as Information Delivery Specification is a standard comes from buildingSMART which ensure openBIM pricipes for exchange of information requirements and validation. Please check at https://www.buildingsmart.org/what-is-information-delivery-spec...

Add Create 3d Automatically Options

The Create 3d Automatically in the Feature Definition toolbar has the potential to be really powerful. Add the ability to have other options. The one I would most like to see is "Profile from Surface" based on vertices, locked to start and end.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration