It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...

This would dramatically reduce the requirement for a vast number of library cells and feature definitions to be created

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

There is currently not a way to project a node from the Drainage and Utility Model to an element (horizontal alignment’s profile model). Profile runs can be created and then projected onto the profile model by conduit linkage. With this enhancemen...

Pressure pipes are essential components of many engineering systems, such as water supply, oil and gas transportation, and power generation. To design and manage these systems, engineers need features that can model the geometry and properties of ...

In Geopak Drainage, once you place a node and attached a catchment, you were able to see inlet calculations. This let the user know if they needed to shift the box to have an allowable spread. It would be great if we could get that feedback withou...

Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...

Ohio DOT likes to see the spread and depth at the edge of the grate. Currently the software reports on the spread and depth at the start and end of the gutter. Would like additional properties to also report the spread and depth at the edge of the...

Geopak is no longer supported by Bentley. At some point, Geopak will not be installed on our machines, but we may need to get the calculations that reside in the GDF file. We need a method that will allow us to extract the information we need from...

We need to be able to label nodes in cross sections drawings automatically. At the moment, this can only be done one node at a time, unlike conduits, which can be labeled automatically.