Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

All ideas

Showing 53
128 VOTE

Functionality to import .12daz file format.

Be able to import strings from .12daz or any format native to 12D
about 2 years ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer 8 Planned

import parcels, survey chains, lines, curves, spirals from GPK

Since GEOPAK is no longer supported. I have heard from Bentley time and time again that we can get to our data out of the GPK and import it into ORD. BUT this is only true for chains, profiles and points. What about Parcels? survey chains? lines? ...
over 1 year ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Planned

Allow the road slope to exceed the gutter cross slope

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Import .xtr files without losing any data

We receive the rail alignment in the form of a .xtr file. In the file itself it is possible to see that there is station, cant, construction and destruction phase, and turnout information, yet when I import it in OpenRail Designer only the alignem...
about 2 years ago in Import/Export / OpenRail Designer 7 Planned

OBM should support multi-model, 2D and 3D workflows similar to OpenRoads

Users currently need to always start with a 3D file in OBM unlike in ORD. Allow users to support the multi-model (2D and 3D) behavior similar to OpenRoads Designer. All decorations should be in the 2D file and all 3D objects in the 3D file. When s...
over 2 years ago in Modeling / OpenBridge Designer / OpenBridge Modeler 0 Planned

ORD Drainage - new properties for gutter spread/depth at edge of grate (not center)

Ohio DOT likes to see the spread and depth at the edge of the grate. Currently the software reports on the spread and depth at the start and end of the gutter. Would like additional properties to also report the spread and depth at the edge of the...
about 1 year ago in Drainage and Utilities 0 Planned

Auto Annotate Point Geometry

Similar to how linear geometry can be annotated upon placing, I would like to extend this functionality to point geometry.
4 months ago in Annotation 0 Planned

Automate Node labelling in Cross Section drawings

We need to be able to label nodes in cross sections drawings automatically. At the moment, this can only be done one node at a time, unlike conduits, which can be labeled automatically.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Clearance Report

Rail industry needs to measure clearance of many elements relative to the track: linear and point. Not all can be done using 3D clash. Some exact value are sometime required by the standards. Typically measurement of a platform edge from the CL bu...
over 2 years ago in OpenRail Designer / Reports 4 Planned

Allow drainage nodes to show up as a cell (catch basin, headwall, end section) in profile view.

Drainage nodes show up in 2D as the cell/feature definition it is designated like an end section. It would be useful if that same feature would show up in the profile view for drainage profiles. It currently works for the "utilities" part of "Drai...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 4 Planned