Long linear elements such as pavement marking and guardrail can be reported on by named boundaries if they are clipped according to the named boundary group. Summary of quantities on plans are often tabulated by sheet. The best methodology for thi...

Ohio DOT would like the ability to create Seeding Reports like those that could be generated within GEOPAK from the cross section candidate elements (or components) with their end width (slope lengths) including similar options that GEOPAK offered...

The Superelevation Report (SuperelevationToCSV.xsl) produces superelevation control lines without parabolic curves at transitions because the stylesheet is not coded to export Non-Linear Curve Lengths. Additionally, it is NOT currently possible fo...

CS0152823 "This user is suggesting to add a note that our STM analysis and design method is based on which AASHTO Code edition. " To add a note regarding LRFD-9 STM changes in output results report

The output reports for a bridge in Leap Bridge Steel is thousands of pages of poorly optimized tables. I have used other software (including LEAP Bridge Concrete, Merlin DASH, etc.) that provide a lot of the same necessary information with much mo...

In the InRoads Check Integrity command, the command would report "OK" for any PIs that did not have curves. We would like the ORD check integrity reports to not report issues at a PI if there are no curves present.

Certain Catchment properties can be stored as collections (composite time of concentration and rational C by Land Cover are 2 that come to mind). For individual catchments these collections can be opened and a report generated, however it is tedio...

It would be great to be able to create a custom report format in the Horizontal Geometry Report and then be able to insert that into a DGN directly from there.

A physical report containing all surface areas and total area. Application use cases for this would include: -Useful for project planning and cost estimation. -Help determine material quantities. -Assists in environmental impact assessments by pro...

In the Deed Writer tool (accessed via Geometry > Reports > Deed Writer), after selecting the reference alignment, the next step prompts the user to identify the Right of Way boundary. Currently, the tool only accepts closed shapes for this b...