In Geopak Drainage, once you place a node and attached a catchment, you were able to see inlet calculations. This let the user know if they needed to shift the box to have an allowable spread. It would be great if we could get that feedback withou...

Geopak is no longer supported by Bentley. At some point, Geopak will not be installed on our machines, but we may need to get the calculations that reside in the GDF file. We need a method that will allow us to extract the information we need from...

It is a common practice to specify a slope as an input parameter when creating a Network.For DU, the slope is rarely exposed and directly editable (only from profile, and if Set invert to Start and or stop is true - and if "Use construction length...

Trench templates are used on pipes for fill quantities. It would be useful if you could place a trench that would automatically assign parametric constraints based on the size and pipe thickness of the pipes. Also, shapes other than a circle are d...

It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...

This would dramatically reduce the requirement for a vast number of library cells and feature definitions to be created

Pressure pipes are essential components of many engineering systems, such as water supply, oil and gas transportation, and power generation. To design and manage these systems, engineers need features that can model the geometry and properties of ...

There is currently not a way to project a node from the Drainage and Utility Model to an element (horizontal alignment’s profile model). Profile runs can be created and then projected onto the profile model by conduit linkage. With this enhancemen...

It would be very helpful and much more efficient if there was an option to insert a vertical bend or curve into a drainage link/pipe from the profile run profile view. Basically, adding the exact same tool that is available in plan/horizontal call...

When laying out watermain pipes the bends can be 45 degrees, 22.5 degrees, etc. These bends are modeled as nodes in our workspace so we can report of them and display them in our drawings. If the angle of the pipe adjusts, we want the node feature...