Add ability to create an Event Point list in the OpenRoads Designer SDK.
I would like to programmatically create a new EventPoint list for an alignment. Looking through the Bentley.CifNET.GeometryModel.Tools.Helpers methods, I found GetEventPointList(Alignment) that returns a List<Bentley.CifNET.GeometryModel.KeySta...
Add option to choose between a vertical offset and a parallel offset for profiles
The profile offset transition has the ability to do an vertical offset of (a part of) an profile. This is a vertical offset. When the line is horizontal, the parallel offset is constant. Please add an option to choose between a vertical offset and...
Cell in GC will have additional properties for IFC
Placed cells with Generative components on alignment which have assigned item types as additional properties. Those properties will be later exported to IFC. Now the additional properties are not shown in GC only in ORD.
In complex geometries it does not seem to be possible to move the center point of a circular curve. When working with different alternatives, it´s common to have two geometries that shares some part of a circular curve with different start or end....
In PRT it was possible to snap a smart line to a specific chainage in plan by using the key-in 'SO=xxx'. In OpenRail the closest tool I can find is Civil Accudraw with station-offset toggled on, but I have found that often CivilAccudraw does not w...
Allow entering a degree of curve (d 00^00'00") as the Radius of the Alignment Table Editor.
When creating curves, an ORD user is allowed to enter a degree of curve (d 00^00'00") as the Radius. Put the same functionality in the Alignment Table Editor.
Add extra Coloum which shows Delta Value in Geometry Report at PC, PT, No Curve PI, SC and CS
Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.
Provide an option to quickly apply combined horizontal and vertical constraints to geometry elements. Where geometry lines (breaklines) intersect, they need to share a common elevation. The current process requires creating profile intersection po...