The Geometry Builder allows us to force tangent restrictions. In some cases there might be some lines/arcs that are tangent and some that are not. It would be an improvement to have the ability to force tangent where needed instead of on all eleme...
Cell in GC will have additional properties for IFC
Placed cells with Generative components on alignment which have assigned item types as additional properties. Those properties will be later exported to IFC. Now the additional properties are not shown in GC only in ORD.
Manual Editing of Cant: Make it easier and allow it to be permanent.
The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
Please add a variable MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_DRAWING that does what MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_SHEET does for sheets but for drawings
0
Future consideration