Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Applications

Showing 1217 of 1359

Add option to use only centerline radius for superelevation calculations

Provide an option or new method to use the centerline radius (instead of inside lane radius) for divided highways that use a Crown pivot method. The Divided Inside pivot method already does this for divided highways that pivot about the inside lan...
about 2 years ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Need the ability to define sequence number other than at the end of the filename

We have a standard naming convention that uses sequence numbers which are in the middle of the filenames. This has been our standard for over twenty years. Additionally, we require each sheet to be in a separate file for multiple flexibility and a...
7 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow entering a degree of curve (d 00^00'00") as the Radius of the Alignment Table Editor.

When creating curves, an ORD user is allowed to enter a degree of curve (d 00^00'00") as the Radius. Put the same functionality in the Alignment Table Editor.
7 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Turn on/off elements in the main dgn will change on all the sheets.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Coincident Sheets with Drawing Boundary

Please add the option to automatically assign coordinate systems to drawing and sheet models based on the design models and to place the sheets coincidently even when they contain drawing boundaries. Right now, we cannot create georeferenced pdfs ...
7 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Will not implement

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Known issue where the undo command undoes all operations or none.

Please try to address this known issue. We are experience it in multiple users in projectwise files. No consistency noted. Is there a undo buffer variable that coul be causing this issue? Thank you. https://communities.bentley.com/products/microst...
over 1 year ago in OpenRail Designer 0

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists