It would be super helpful if I didn't have to search two different property menus for where to change specific properties. If the general properties menu and the ORD DU properties menu could be more centralized into one properties menu, this would...
Ohio DOT would like the ability to create Seeding Reports like those that could be generated within GEOPAK from the cross section candidate elements (or components) with their end width (slope lengths) including similar options that GEOPAK offered...
Allow the road slope to exceed the gutter cross slope
My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...
We need that when writing down the singular points of a railway deviation (P0, P1, P2 and P3), they are joined by straight lines P1 with P2 and P0 with P3. See attached image. In fact, the V8i version did represent the detour scheme. Thank you!
Ability to have corridor/linear template pivot at end of alignment
Currently when developing a object that is at a skew, whether it be a road, bridge, culvert, or other detail modeling. If the start/end of the object is at a skew compared to the alignment that it is attached to, it is difficult to model. The user...
Superelevation lanes have start and end points by default in tangents
Currently if you place a superelevation lane on a tangent alignment, no points will show up in the superelevation editor. I would like that automatically even in tangent sections, the start and end points are placed in the superelevation editor so...
Add "Point" column to the table in the Corridor Objects-Point Control window to show which point is being controlled
As a Highway Designer I want the Corridor Objects-Point Control window to include a column in the table that shows which point is being controlled so that I can sort based on that point name to quickly determine which point controls applied to tha...
Our industry requires to provide accurate horizontal alignment's annotation which shows element's length between turnouts (not only length of whole plan elements). This is what could be done by "Switch Height Plan" tool in Power Rail Track (PRT). ...
Exported TIN surface must carry same edge method on importing.
Exported surface in TIN format not keeping the same edge method while importing it in new .dgn file. So, it is expected to get such functionality where the exported surface should carry the same edge method or while importing any surface it should...