Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1194

Trim with Connection Points/Regions on opposite sides of cell

I would like to have the ability to put connection regions and connection points on opposite ends of cells, specifically aprons. Currently, the apron won't trim with this setup.
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Standard Report Formatting

We use reports generated in the Civil Reports Browser to export reports that go to contractors in the field. We often run into issues with the formatting of the report not being set correctly. This problem is compounded by the fact that formatting...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Offset Alignment - Controlled by Station, Offset and Cross Slope.

An OFFSET ALIGNMENT / GEOMETRY CHAIN command would be a gamer changer for ORD. Most of our geometry including "edge of pavement", "curb" and "ditches" are controlled by station offset cross slope from a control line. Currently to create offset geo...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Channels Attach to other nodes besides headwall

If ditches do become channel features, KYTC would need channels to then be able to attach to other node types besides headwalls since we have many conditions and locations where they outlet into inlets of various types.
10 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Flood Volumes - Surface analysis between three surfaces

It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.
10 months ago in Analytics / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 1 Future consideration

Checkbox to turn on-/off alignments

It would be useful to be able to turn on-/off single alignments. Perhaps with a checkbox in the "OpenRail Model" section in the explorer, just like the ones in the "Feature definition" section in OpenRail Standards. This could probably be handy wi...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Add .JXL file format

It would be nice if the Trimble Link Import op tion of ORD Survey would allow for .JXL file format to import.
almost 2 years ago in Import/Export / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 1 Future consideration

ITL Copy Components

Add ability to copy points, components and sets of components
10 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Selection of named boundary with different associations

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
10 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to print without needing to go through named boundaries

We were previously able to drop a border cell in any file to easily be able to print and now it is not
10 months ago in Drawing Production / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Already exists