Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

All ideas

Showing 54

Placement Point for design and baseline Station/offset

The optimal placement point for design of drainage nodes not always the preferred callout point for construction. The request is to be able to have an additional "Construction" layout point to get station and offset reports that are different than...
9 months ago in Drainage and Utilities / OpenRail Designer / OpenSite Designer 0 Planned

Inclusion of Pavement Striping in ConceptStation Quantities and Cost Configuration

The Quantities and Cost Configuration in ConceptStation currently only includes Street Markings (turn arrows/symbols). Even if Linear Markings (edge/centerlines and guidance striping) or Transverse Markings (crosswalks/stop bars) are present in th...
9 months ago in OpenRoads ConceptStation 0 Planned

Ability to change slope of gutter component

Would like to add ability to where we can change the slope of gutter components
9 months ago in OpenRoads ConceptStation 0 Planned

OpenRoads Deed Writer - Bearing Formats

Open Roads Deed Writer bearing formats should be provided. North 84 Degrees 7 minutes 20 seconds East N 84 7 20 E
10 months ago in All Other / OpenRoads Designer 0 Planned

Open Roads Deed Writer - Area Formats

Open Roads Deed Writer should provide options to use multiple measurement formats such as Square Feet instead of Acre.
10 months ago in All Other / OpenRoads Designer 5 Planned

Catchment Areas by shape

If I could select all shapes and have it create all catchments at once that would save a lot of time. It would be great to have a dialogue box pop up where defaults can be changed.
10 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

SignCAD - Option to Rotate/Mirror Graphics

In previous SignCAD versions, we could rotate or mirror graphics. That is not longer possible. This makes it much more difficult to create custom signs. We have to hunt for a standard graphic that is available or create a new one. This recently ha...
10 months ago in OpenRoads SignCAD 0 Planned

Top of cheekwall elevation item type

it would be useful to add a top of cheekwall elevation as an item type.
12 months ago in OpenBridge Modeler 0 Planned

Show the Link Size within the Link Summary Tab

The window that pops up after a hydraulic model run for design or analysis includes a "Calculation Detailed Summary". The Link Summary tab does not currently show the designed link size. Showing the link size in the Link Summary tab will allow the...
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Allow different levels for different conduit sizes in the same catalogue.

For Conduits, on our 2D plans, we show a different linestyle for each size of pipe. In InRoads, we would enable centerline display using these different linestyles. This linestyle is a wide dashed line with solid edge lines. We cannot replicate th...
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned