ORD Drainage - new properties for gutter spread/depth at edge of grate (not center)
Ohio DOT likes to see the spread and depth at the edge of the grate. Currently the software reports on the spread and depth at the start and end of the gutter. Would like additional properties to also report the spread and depth at the edge of the...
Open API to programmatically create Feature Definitions and Feature Symbologies.
It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...
It would be super helpful if I didn't have to search two different property menus for where to change specific properties. If the general properties menu and the ORD DU properties menu could be more centralized into one properties menu, this would...
Allow the road slope to exceed the gutter cross slope
My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...
Display transparent catchment boundary at the cursor when relocating an inlet.
Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...
Enhancement to Create Project Node to Element Tool
There is currently not a way to project a node from the Drainage and Utility Model to an element (horizontal alignment’s profile model). Profile runs can be created and then projected onto the profile model by conduit linkage. With this enhancemen...
The window that pops up after a hydraulic model run for design or analysis includes a "Calculation Detailed Summary". The Link Summary tab does not currently show the designed link size. Showing the link size in the Link Summary tab will allow the...
Allow drainage nodes to show up as a cell (catch basin, headwall, end section) in profile view.
Drainage nodes show up in 2D as the cell/feature definition it is designated like an end section. It would be useful if that same feature would show up in the profile view for drainage profiles. It currently works for the "utilities" part of "Drai...
Use Tabs to Separate Items for Each Design Element in ORD Drainage
It is cumbersome to have to scroll through several pages of information to design and review drainage elements. KYTC would like to see tabs used, similar to those used in InRoads S & S. Each element (storm sewers, strom sewer inlets, drainage ...