Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

User Interface

Showing 6

Open profile from profile view

While I am in a profile view, I would like to be able to open a new profile from a different horizontal without having to activate the 2D view. It is a small thing but would be nice.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 4 Already exists

feature definition - browser all element that used a specific feature definition

Get a list of elements using a specific feature definition. Similar to level usage. This "select by graphic filter" filter only feature type that compose a terrain model.
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 5 Already exists

Allow user to change default settings

When I open a profile view, the default vertical exaggeration is 10. That is way too much. And I hate having to change it every time I open a profile view. Everyone is diffferent, though. I'm sure some folks love it. It would be nice if there was ...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 1 Already exists

Buttons in Level Display that stores and restores the status of levels

Once stored, it will keep track of which levels are turned on and off at the time of pressing stored. Then pressing restore will return the levels back to what they were. This would be useful if you needed to turn off some levels but want to retur...
over 1 year ago in User Interface 1 Already exists

Bring back Active Chain Control or Similar Tool

In GeoPak, the Active Chain Control tool was very useful for selecting a particular chain or alignment and having the location information (station, offset, etc.) be display in a dialogue box. The location information would live track with the loc...
6 months ago in Modeling / OpenBridge Designer / OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 6 Already exists

Switching between referenced OBD models from an ORD file (after attachment).

If multiple bridge options are required, placing these options within the same dgn, but in separate models is a good practice. However, from ORD trying to change which OBD model is viewed (after it's been attached) does not work. It can be reattac...
over 1 year ago in User Interface 0 Already exists