Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

CANT

Showing 15

Add Equilibrium Constant to Design File Settings

We need better access and configuration for this constant. There is no place to set this constant.
6 months ago in CANT / OpenRail Designer 0 Future consideration

Gauge and Cant Reports on Regression Information

Based on the way the new regression tools work for importing regression lines we no longer have a way of running gauge and cant reports on existing alignments based on LHR/RHR surveys.
6 months ago in CANT / OpenRail Designer / Regression Analysis / Reports 0 Future consideration

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
10 months ago in CANT / Geometry / OpenRail Designer 0 Future consideration

Existing Cant

Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...
11 months ago in CANT / OpenRail Designer 0 Future consideration

Customisable Track Design Parameters

There is currently no way to view what cant ratios and related cant values the software is applying to the alignment. Nor is there an option to change the maximum and minimum values applied. The software should have an option to amend the followin...
about 1 year ago in CANT / OpenRail Designer 0 Future consideration

Numerical display for applied cant

Recommended that a when using the cross-section tool to view the applied cant along the alignment, the tool displays the cant as numerical value on the cross-section. The number should be generated automatically and displayed next the chainage...
about 1 year ago in CANT / OpenRail Designer 0 Future consideration

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

Linking multiple cant alignments with a dependency into a referenced container model

My company plans to undertake large route alignments, but broken down into smaller alignment sections for different contract areas. Currently, we are 'stitching' the smaller sections into a routewide federated model by using Single Offset Entire E...
over 1 year ago in CANT / OpenRail Designer 2 Future consideration

Cant editor parameters before creating cant

In the Cant Editor, there is a tool called validate data which allows you to add in your design parameters and then check against the cant the Openrail has already automatically generated. although a good tool, i just think it would be better Open...
over 1 year ago in CANT / OpenRail Designer 1 Future consideration

Cant editor process button

When editing cant values in the edit cant feature it can be painfully slow because it recomputes all the values and redraws the table after every edit. It would be a nice to have the option of making all the edits you want and then having a button...
almost 2 years ago in CANT / OpenRail Designer 0 Future consideration