Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

OpenBridge Designer

Showing 25

Construction stage analysis for LEAP Bridge Concrete

Construction stage analysis for precast beams and cast-in slabs is important for composite deck design.
about 5 hours ago in OpenBridge Designer 0 Needs review

Fiber Mesh Cross Sectional Analysis

Con sider adding fiber-mesh tools for cross section analysis to RMBRIDGE. This allow the use of different materials in the cross section. This is important in seismic analysis for the definition of the Moment-Curvature properties. This feature is ...
2 months ago in Analytics / OpenBridge Designer 0 Needs review

PMM non-linear springs

We would like to ask a PMM non-linear spring for modeling Plastic Hinges for reinforced-concrete Columns. This PMM springs are used for modeling the Moment-Rotation (M-R) behavior for different axial loads (P). The PMM spring should be able to cap...
about 2 months ago in Analytics / OpenBridge Designer 0 Needs review

provide highlighting or red text for the following note to better stand out when value is non-zero

Enhancement Request to provide highlighting or red text for the following note to better stand out when value is non-zero.
about 2 months ago in OpenBridge Designer / User Interface 0 Needs review

Include ability to model curtain wall under end bent

Please include ability to model curtain wall under end bent, similar to backwall. This curtain wall is a great tool when working on projects when new fill required to place is not significant enough to just an independent retaining wall but is sig...
6 months ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

Staged Construction Optionality

Staged construction is a very common construction methodology. The current process of modeling staged construction in OBM is to model each stage as separate bridges. This creates problems when modeling a steel I-girder bridge as the cross-frames b...
over 1 year ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
10 months ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review

Model a straight bridge on a curved alignment

The ability to create a straight bridge when the alignment transitions from tangent to a horizontal curve on the bridge. Currently the deck ends are controlled by the bridge skew from a radial line at the end of the deck rather than from the tange...
over 1 year ago in Geometry / OpenBridge Designer / OpenBridge Modeler 0 Needs review

Approach Slab Line Offset

Currently the approach slab line uses an offset distance to place it. that offset value just shifts the line that distance along the alignment, which is not what we want especially on curved bridges. That offset distance needs to be a copy paralle...
over 1 year ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

RM Bridge update to use the correct AASHTO reduction factor for reinforced/prestressed concrete based on tensile strain in reinforcing at ultimate limit state.

The current RM bridge ultimate capacity calculations allow for material reduction factors only, which are not used by AASHTO for reinforced and prestressed concrete. AASHTO concrete reduction factors for flexure and P-M capacities are based on the...
9 months ago in OpenBridge Designer 0 Needs review