Add ability to draw Ahead/Back Tangent line for full length from PC to PI and from PT to PI
Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...
Ability to define non-uniform cross section named boundaries
The ability to define the location and width of cross section named boundaries that are not uniform along the length of the project. For example, regular sections might be 500 feet wide but some areas require wider sections for ramps, side roads, ...
We would like the ability to add Mile Post annotations to alignments. One way to do this would be to add a "Begin Mile Post" property and the ability to configure the annotation group to display whole and fractional mile post annotations along the...
What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....
"Curve Set" text favorite annotation should annotate entire curve set
Under the Curve Set option under Location, an option for Spiral Left Middle, Spiral Right Middle, Curve Left Middle, Curve Right Middle needs to be added. Ability to annotate the Middle of a Spiral and/or Curve within a Curve Set. These options ne...
Commands to Place Node and Conduit <Type> (e.g. Place Manhole, Place Stormwater Conduit)
At the moment, you run Place Node, then set the type of node by picking a feature definition. However, you normally know what type of node that you want to place, such as a manhole for example,so it would be more intuitive if the ribbon contained ...
We need to be able to label nodes in cross sections drawings automatically. At the moment, this can only be done one node at a time, unlike conduits, which can be labeled automatically.
Users are asking for item types for
Parametric cells. Primarily for quantities reports.
We tag each element, but can we expose volumes for each element in a
Parametric cell. The most important things are Volume, Surface Area, Length(Column, Pile,...