The window that pops up after a hydraulic model run for design or analysis includes a "Calculation Detailed Summary". The Link Summary tab does not currently show the designed link size. Showing the link size in the Link Summary tab will allow the...
Restrict limits of unsuitable removal to only within grading limits
See this thread from the Bentley OpenRoads Community: https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/226295/ord-2021-r2-limits-of-unsuitable-removal
Annotate Slope of terrain between points in Cross Sections
Civil labeler only works for 3D linear features (points). It`s impossible to annotate the slope from the terrain between two points. If you try that, the whole terrain section is selected and the command fails. A great example is a cross section o...
Enhance Annotation Definitions (Add text frame option and associate leader line to text)
Currently when creating/using annotation groups, the annotation definition can place a leader line. But when the annotation is placed the leader line is not associated with the text so if I move the text the leader line does not move with it. Simi...
ROW Workflow - Functionality in Connect equivalent to Geopak COGO input files
In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows:
...
Profile annotation in the point shows slope of the middle of the left and right line
Please see attached file. User would like to be able to show slope of the middle of the profile lines, in annotation that is assigned to a point. Annotation shown on the printscreen.
Add the ability in a Plan Annotation Group to label non-curve PI's with the deflection angle
I would like to request a new alignment annotation that labels a non-curve PI in a horizontal alignment with the station, the deflection and piece of text that says "no curve". I can create the text favorite that displays the station and the text ...
When a corridor clip is applied, the 2D geometry is not affected by that corridor clip, only the 3d mesh is clipped. I would like an option to choose whether you'd also like to clip the 2D geometry.
Allow users to see horizontal and vertical alignments while in view only mode.
Wise users open files in read-only mode when they don’t intend to change the file. ORD should promote good file practice to allow us to view geometry when we are in view only mode.
Support spaces for bearing input in geometry tools
The geometry tools should allow for spaces between degrees minutes and seconds (N78 34 22E). This format is supported in the Geometry Builder but not the other geometry tools and the inconsistence is frustrating. Currently you have to enter either...