Ability to lock Parametric Constraint Start/End to XY or Stations
There are many different situations where users may want Parametric Constraints to be locked to specific stations or XY locations. An additional column in Corridor objects with this option would be very valuable for users to identify and control d...
Horizontal and vertical regression values displayed in mm
Reporting horizontal slues and vertical lift/lowers interactively in the plan or profile model always displays as per the working unit, which I have set to metres. It would be useful to display these values in millimetres
Regression: add a "Remove regression points" command both for H and V regression line
We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...
The ability to show the cross-pipes in profile runs right now is by default a user preference. It would be nice if this could just be a standard function or at least set to "True" as a default to be turned off if desired.
Label all the points in a superelevation section with Civil Labeler
Superelevation is a tabular note that goes on the general info sheet with the super elevation diagram, so we usually just fill out the info in that tabular note. Designers just blow up the tabular note to add lines and make it work per project. If...
When creating centerline geometry you may need it to be parallel to outside boundaries like Right of Way. It would be convenient to be able to select that snap and use it like it works for MicroStation lines.
1
Future consideration