Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Geometry

Showing 142 of 1186

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
7 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to Edit Event Point List within Actived Referenced DGN

Activating a referenced dgn with geometry does not allow editing the Event Point List.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profiles and Sections with no sheets

I am going back to the SS2 versions. I would like to see an option to produce 1 profile for the entire alignment. Give it the station range and produce the profile in Microstation with an option to annotate The same for Cross-Sections. Station Ran...
over 1 year ago in Drawing Production / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Improve civil geometry constraints

Provide an option to quickly apply combined horizontal and vertical constraints to geometry elements. Where geometry lines (breaklines) intersect, they need to share a common elevation. The current process requires creating profile intersection po...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Existing Top of Rail Elevations

Needs a more efficient way to annotate existing top of rail elevations in a profile view.
over 1 year ago in Annotation / Geometry / OpenRail Designer 2 Future consideration

Add extra Coloum which shows Delta Value in Geometry Report at PC, PT, No Curve PI, SC and CS

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Snap to specific chainage in Plan

In PRT it was possible to snap a smart line to a specific chainage in plan by using the key-in 'SO=xxx'. In OpenRail the closest tool I can find is Civil Accudraw with station-offset toggled on, but I have found that often CivilAccudraw does not w...
7 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
over 1 year ago in Geometry / OpenRoads Designer 0 Already exists

Ability to Change Feature Name of Element Within Complex Element

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.
over 1 year ago in Geometry / OpenRail Designer 0 Already exists

Geometry builder fix components

As in the geometry connector, the geometry builder needs to be able to fix certain elements
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration