Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...
Recommended that a when using the cross-section tool to view the applied cant along the alignment, the tool displays the cant as numerical value on the cross-section.
The number should be generated automatically and displayed next the chainage...
Based on the way the new regression tools work for importing regression lines we no longer have a way of running gauge and cant reports on existing alignments based on LHR/RHR surveys.
Make the Cant tool more useful. Currently, we set the speed then apply cant and it spits out some random cant values, which are unrealistic. Then we can set the cant parameters and the software proves the values are unrealistic and we have to edit...
Manual Editing of Cant: Make it easier and allow it to be permanent.
The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
0
Future consideration