Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1194

Create multiple long sections/profiles in the same model space

When creating profiles/long sections for track vertical geometry, ORD creates an individual sheet view and model view for each sheet. This creates a large amount of work when trying to bulk annotate or export long sections for drafting. It would b...
about 1 year ago in Drainage and Utilities / Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

label contours

label contours from inroads. there are times we have to label elevated "graphic" lines (aka contours and or benches without having a terrain model). was very helpful in inroads)
over 1 year ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 8 Already exists

add distance between VPI to annotations in profiles

We need this to label our profiles optimally there'd be two values, once the horizontal (projected) distance and once the true (slanted) distance between to VPI's
over 1 year ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Additional Shoulder Rollover Slope Rows (3D Modeling - Templates)

I would like to make a suggestion on an improvement to template design for 3D Modeling in ORD. The Rollover values tool in superelevation template design is incredibly helpful, as it saves time by calculating the proper shoulder super rates accord...
about 1 year ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Switching between referenced OBD models from an ORD file (after attachment).

If multiple bridge options are required, placing these options within the same dgn, but in separate models is a good practice. However, from ORD trying to change which OBD model is viewed (after it's been attached) does not work. It can be reattac...
over 1 year ago in User Interface 0 Already exists

Add an ExtendLine Code to Survey

This code would be similar to the DIST command, except it would allow the crews to add a taped distance to the last segment of a figure, which would extend that segment by that value. It would be similar to a DIST commend except instead of turning...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Fix DIST Command in Survey to InRoads Survey Operation

The DIST Command in Open Roads is almost identical to the InRoads version with one problematic exception. Open Roads uses the last two actual shots to determine the direction to turn the 90-degree angle to generate its points. InRoads would allow ...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Add Single Point Arc that is identical to InRoads Surveys

The Sigle Point Arc command in InRoads survey would create true tangent arcs from the incoming and outgoing tangents. The ArcSingle in Open Roads does not. This frequently results in bulges in figures if the uncoded PC and PT points are not perfec...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Add Extend Arc Code to Survey (as in InRoads Survey)

This code was found to be very useful in InRoads Survey and without it, we need to retrain the crews to change their workflows.
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Add extra Coloum which shows Delta Value in Geometry Report at PC, PT, No Curve PI, SC and CS

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration