Need Support? Let’s guide you to the right answer or agent.

OpenCivil Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1194

Trim with Connection Points/Regions on opposite sides of cell

I would like to have the ability to put connection regions and connection points on opposite ends of cells, specifically aprons. Currently, the apron won't trim with this setup.
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Standard Report Formatting

We use reports generated in the Civil Reports Browser to export reports that go to contractors in the field. We often run into issues with the formatting of the report not being set correctly. This problem is compounded by the fact that formatting...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Channels Attach to other nodes besides headwall

If ditches do become channel features, KYTC would need channels to then be able to attach to other node types besides headwalls since we have many conditions and locations where they outlet into inlets of various types.
10 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Offset Alignment - Controlled by Station, Offset and Cross Slope.

An OFFSET ALIGNMENT / GEOMETRY CHAIN command would be a gamer changer for ORD. Most of our geometry including "edge of pavement", "curb" and "ditches" are controlled by station offset cross slope from a control line. Currently to create offset geo...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Flood Volumes - Surface analysis between three surfaces

It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.
10 months ago in Analytics / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 1 Future consideration

Add Geometry Point "Name &/or ID" as an option for "Columns to Add" When Reporting on Geometry Points

In order to create a "Set Out Point Table" which is dynamically linked to geometry points in a DGN, we first need to report on the Points. Currently for Geometry Points, there is No Option to include the Geometry Point Name or ID. This Needs to be...
3 months ago in OpenRoads Designer / OpenSite Designer / Reports 1 Future consideration

When using Cross Section Navigator, ability to see what the respective named boundary in plan view

When using the Cross Section Navigator to review the XS, I would like the ability to see the named boundaries highlight according to the cross section that you are looking at. This was a feature in OpenRoads Technology.
3 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer 0 Future consideration

ITL Copy Components

Add ability to copy points, components and sets of components
10 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Selection of named boundary with different associations

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
10 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to print without needing to go through named boundaries

We were previously able to drop a border cell in any file to easily be able to print and now it is not
10 months ago in Drawing Production / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Already exists